Hello everyone,
I am new to WUFI 2D and have a couple of questions about default assumptions and result interpretation. I have already reviewed the WUFI 2D example PDF, but I am still unsure how to apply the guidance to my case.
For the default Initial Conditions, is it generally acceptable to leave the default values as they are, or should they be adjusted for each material? If they should be adjusted, what is the recommended way to define material-specific initial moisture/temperature conditions?
After running the simulation, what are the key outputs I should review to confirm that the results are reasonable? For example, should I focus on total water content, material-specific water content, relative humidity/temperature at monitoring points, drying potential, or year-to-year moisture accumulation?
Any practical guidance, examples, or beginner-level checks would be greatly appreciated.
Thank you.