initial condition
Posted: Fri Jun 10, 2011 5:31 am -1100
Hi dear members
My simulation diverge so I do severals actions in order to find what could be the reason.
To do that I checked the results in WUFI2DMotion application.
I took the step 0 and I displayed the watercontent.
And I was very suprised to note that Wufi have changed my initial values.
By example a value of w= 255 for a lime concret layer (matérial from database) was changed by w= 362
Why Wufi changed initial conditions (at time 0), before any calculation.
thanks for any help
regards
PS : I checked that the value of w is lower than the maximum of water (porosity of 0.27)
My simulation diverge so I do severals actions in order to find what could be the reason.
To do that I checked the results in WUFI2DMotion application.
I took the step 0 and I displayed the watercontent.
And I was very suprised to note that Wufi have changed my initial values.
By example a value of w= 255 for a lime concret layer (matérial from database) was changed by w= 362
Why Wufi changed initial conditions (at time 0), before any calculation.
thanks for any help
regards
PS : I checked that the value of w is lower than the maximum of water (porosity of 0.27)