WUFI

Hi Christian

I have had the exact same issue with VTT (Fin Mould). After upgrading my computer and restarting WUFI I had to re-download and install the Fin Mould processor and then I also had an alert to re-install Java to run the program.

Now I am in the same position as 'hbreaux from 29 oct ...

Good afternoon, I am hoping to receive some further information regarding infiltration and exfiltration of air through assemblies for warm climates. I use the IPB Infiltration model to assess the effect of air moving to the outside, however, as I often model warm/humid climates I also want to assess ...

Hi Thomas
Thank you very much for your suggestions, it was extremely helpful. I tried a couple of the options you suggested and through testing multiple variables was able to reach a qualitative conclusion due to the results not varying too much at all. Thanks again for your comprehensive advice ...

Hello
I am trying to model a wall that is only 30mm from a neighbouring building. Has anyone any guidance on the best way to simulate the external conditions one might expect in this situation?
One idea is to model the neighbouring wall and enter the 30mm space as a ventilated cavity and add a ...

Hi Christian
Yes, the above issue appears to be solved in WUFI Pro 6.4.
Thank you,
Madonna

Hi Christian

For information, this is still occurring in WUFI Pro 6.3. I have to re-select the 'AC with humidification' each time I switch between different Cases. It doesn't seem to save the internal climate selection.

All the best, Madonna