Initial conditions form file in WUFI 2D
Posted: Thu Feb 08, 2024 12:57 am -1100
Hello,
I needed help with WUFI 2D on two issues:
1) How can I enter, as the initial conditions of a construction element (made up of various materials), the final T and RH profile of a previous simulation? Should I remove these profiles from wufiGraph or from WUFI2D motion?
2) I read that it was possible to extract the T and RH conditions used as boundary conditions (input) from the Wufigraph results file (just to check). To do this, I thought I had to select a point on the grid corresponding to that boundary condition (usually shown in blue) and ask for the graph. It turns out that when I do this I get a T and RH equal to zero (?).
Thanks in advance,
Teresa Stingl Freitas
I needed help with WUFI 2D on two issues:
1) How can I enter, as the initial conditions of a construction element (made up of various materials), the final T and RH profile of a previous simulation? Should I remove these profiles from wufiGraph or from WUFI2D motion?
2) I read that it was possible to extract the T and RH conditions used as boundary conditions (input) from the Wufigraph results file (just to check). To do this, I thought I had to select a point on the grid corresponding to that boundary condition (usually shown in blue) and ask for the graph. It turns out that when I do this I get a T and RH equal to zero (?).
Thanks in advance,
Teresa Stingl Freitas