output an initial condition-or-continue last calculation

All about WUFI 2D
Post Reply
yuan
WUFI User
WUFI User
Posts: 9
Joined: Mon Jan 21, 2019 2:51 pm -1100

output an initial condition-or-continue last calculation

Post by yuan » Fri Nov 08, 2019 1:41 am -1100

I was calculating hygrothmeral behavior of the ground, and it needs a long time to heat up. So I was wondering is it possible to output the temperature distribution results at the final stage, and then input it as an initial calculation in a new calculation?
Thank you so much!

Christian Bludau
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 854
Joined: Tue Jul 04, 2006 10:08 pm -1100
Location: IBP Holzkirchen, the home of WUFI
Contact:

Re: output an initial condition-or-continue last calculation

Post by Christian Bludau » Mon Nov 11, 2019 2:16 am -1100

Hi Yuan,
yes, thats possible.
Open the results in WUFI 2D Motion, press backspace to get to the last time step of your calculation or use Ctrl + G to go to the step to export.
Do a right-click on temperature and select extract -> initial conditions. Do that as well for the water content or relative humidity.

In WUFI 2D go to "Initial Conditions" -> "Use initial conditions from file" to import these files.
Christian

yuan
WUFI User
WUFI User
Posts: 9
Joined: Mon Jan 21, 2019 2:51 pm -1100

Re: output an initial condition-or-continue last calculation

Post by yuan » Tue Nov 12, 2019 1:15 am -1100

Thank you so much dear Bludau!!! that helps me a lot!

Yuan

Post Reply