Using Wufi to Predict External Condensation

Everything that didn't fit in any other topic
Post Reply
Posts: 1
Joined: Wed Jan 30, 2019 3:22 pm -1100

Using Wufi to Predict External Condensation

Post by Sam@inhabit » Wed Jan 30, 2019 3:28 pm -1100

Hi All,

We have made a glass material based on the following thread to model external condensation risk in Darwin.

We are comparing the performance of single vs double glazing in regard to reducing the risk of external condensation in Darwin- see attached wall make up.

Can anyone identify any flaws in this methodology.


Single Glazing.JPG
Single Glazing.JPG (44.3 KiB) Viewed 67 times
IGU.JPG (43.62 KiB) Viewed 67 times

Christian Bludau
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 786
Joined: Tue Jul 04, 2006 10:08 pm -1100
Location: IBP Holzkirchen, the home of WUFI

Re: Using Wufi to Predict External Condensation

Post by Christian Bludau » Thu Jan 31, 2019 12:36 am -1100

Dear Sam,

for model reasons, in WUFI no dew water can form on the surfaces directly. So to calculate the amount dew-water on a surface, you will need to insert a layer, which can store the water. You need a layer which can store some water (high porosity) and it should not highly influence the transport properties from the ambient conditions to the surface. For example 1mm of air layer (with the short name) would be usable.

Please also note, that the following parameters will highly influence the amount of dew water:
  • long wave radiation (the climate file has to contain the atmospheric counter radiation as exact as possible)
  • short wave absorption of the surface
  • long wave emission of the surface (the emission will change to about 1 with the increasing amount of dew water. WUFI can not take that in account directly. So it may make sense to have a closer look on time spans with dew water by performing further calculations with changed long wave emission of the surface)

Post Reply