simulation of rising damp

evahajkova · Post by **evahajkova** » Sun Jun 12, 2016 11:08 pm -1100

Hello,

I would like to ask, how to model the water rising from the subsoil? I have a brick masonry pillar with both sides underground by placing sand on both sides of the wall. The sand was saturated (RH 95%) during the test. The lower edge of the pillar is permanently immersed in water. How should I simulate a layer of water?

Thank you for your advice

Eva

Christian Bludau · Post by **Christian Bludau** » Mon Jun 13, 2016 12:25 am -1100

I create a wac file containing rain in each our and use it as boundary condition. See also:
viewtopic.php?f=4&t=1116&p=3190
and
viewtopic.php?f=4&t=654
Demo-Films about wac are here:
https://wufi.de/de/service/downloads/er ... fuer-wufi/
Sorry, page is in German only at the moment, but the movies are English.
Christian

evahajkova · Post by **evahajkova** » Sun Jun 19, 2016 9:52 pm -1100

Hello Christian,

Thank you so much for your advice, it was very helpful

Eva

simulation of rising damp

simulation of rising damp

Re: simulation of rising damp

Re: simulation of rising damp