Comparison of parameters in WUFI Mould Index VTT and VTT-model

[anderue]

Hi.

How does the parameters for "Type of surface" and "Type of wood" compare to the parameters W and SQ in the VTT-model?
In the VTT-model, the parameter W is set to 0 for pine and 1 for spruce. Is this the same parameter as "Type of wood" in the VTT-program? In the VTT-program one can choose between Softwood (value = 0) and hardwood (value = 1). This would mean that softwood = pine and hardwood = spruce?

The same goes for type of surface. I assume that this value equals to the SQ-value in the VTT-model. This would mean that planed surface = sawn surface (SQ = 0) and rough surface = kiln dried surface (SQ=1).

So, I assume that the parameters in the VTT-program and in the VTT-model are the same, but I may be wrong. Does anybody know if I am correct?

[saricioglu pelin]

Did you learn the answer ? i wonder that..
Thank you