Sketchup plug in not saving geometry

All about WUFI Passive
Post Reply
Melinda
WUFI User
WUFI User
Posts: 1
Joined: Wed Apr 12, 2017 4:33 am -1100

Sketchup plug in not saving geometry

Post by Melinda » Wed Apr 12, 2017 4:55 am -1100

Hi, This is more of a sketchup question but hoping someone can help me. I'm using sketchup with a model that was originally built in archicad to export into wufi passive. I can select and label the faces but when I try to save or export the geometry I get an error message that none of the elements have been selected. I have another model that is much simpler that works but for some reason with this model even though when I right click on the faces I can confirm that the wufiplus properties are properly identified, however, when I try to save or export sketchup says there are no elements selected. Thanks for your assistance.
Melinda
sketchupwufierror.PNG
sketchupwufierror.PNG (90.34 KiB) Viewed 7036 times

hbreaux
WUFI User
WUFI User
Posts: 38
Joined: Mon Jun 20, 2016 2:34 am -1100

Re: Sketchup plug in not saving geometry

Post by hbreaux » Mon Apr 17, 2017 8:15 am -1100

Hi Melinda,

I suggest creating much more simplified geometry freshly in SketchUp. To save time, perhaps use imported ArchiCad geometry as a base group to build over then delete it from model when done. I've successfully followed this workflow a number of times with Revit.

Best,

-Hans

Post Reply