Differences in balance 1 and 2

All about WUFI Pro
Post Reply
carolinarecart
WUFI User
WUFI User
Posts: 3
Joined: Fri Apr 01, 2022 8:06 am -1100

Differences in balance 1 and 2

Post by carolinarecart » Wed Jan 18, 2023 8:33 am -1100

Hello,

I'm simulating an assembly using six different climates. In the first simulation cycle, I got over 20 convergence failures and significant differences in balance 1 and 2 in two climates, so I increased the grid and enabled the adaptative time control (steps 3, max stages 5). I re-ran the simulations and did not get any converge failure; however, the balance 1 and 2 were off from each other (more than one or digit differences). How can I increase the numerical quality of my simulations? I have to say the problems are for hot and humid climates, whereas the rest (cold and cool climates) results look fine. Is there any approach/advice I could follow?

Thanks in advance!

Carolina

Post Reply