Transfer coefficients

Everything concerning the adequate application of WUFI in the USA and Canada depending on local conditions e.g. architecture, building codes, standardization, laws et cetera.
Post Reply
bbarms
WUFI User
WUFI User
Posts: 2
Joined: Thu Sep 27, 2012 8:19 am -1100
Location: Brooklyn, NY

Transfer coefficients

Post by bbarms »

I am new to the forum and maybe this has been considered, but I have not found an answer, Under the Surface transfer coefficients box there is the interior (right side) the line for heat resistance is there, however under the discription it says exterior wall and I am unable to change that to say interior wall, is it possible to change that or am I misundersting the line item? I am asking because the question was raised with me.
thank you
Manfred Kehrer
WUFI International Support Team
WUFI International Support Team
Posts: 351
Joined: Thu Mar 10, 2005 2:17 am -1100
Location: Northbrook, IL; USA
Contact:

Post by Manfred Kehrer »

WUFI Pro should also have the option to select "Partition Wall (inner)" which maybe what you are looking for.
Manfred
Wiss, Janney, Elstner Associates, Inc.
Official WUFI® Collaboration Partner for USA/Canada
Enjoy WUFI® :) .... It is easy and complex.
bbarms
WUFI User
WUFI User
Posts: 2
Joined: Thu Sep 27, 2012 8:19 am -1100
Location: Brooklyn, NY

Transfer coefficients

Post by bbarms »

Thanks Manfred, That was it thanks, sorry for a silly little question
Bill
Post Reply