DXF-Import (was Exporting raw data from WUFI 2D)

All about WUFI 2D
Post Reply
saricioglu pelin
WUFI User
WUFI User
Posts: 5
Joined: Fri Jun 03, 2022 12:07 am -1100

DXF-Import (was Exporting raw data from WUFI 2D)

Post by saricioglu pelin » Sun Jun 05, 2022 9:41 am -1100

Hello everyone,
İ am very new in WUFI. And so i have a lot of problems about exporting my draw from Autocad into WUFI 2D...i can not understand what problem is it...Because i draw all lines as polyline and also save as dxf. but WUFI can not seen ...why? please answer me..
Regards

Johannes Amos
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 4
Joined: Sun May 29, 2022 11:08 pm -1100

Re: Exporting raw data from WUFI 2D

Post by Johannes Amos » Tue Jun 21, 2022 8:19 pm -1100

Hi,

when you draw your construcion make sure you use closed polyline rectangles only. If the rectangle is not closed, the angle is not 90° or your construction shows other geometric shapes it cannot be imported. I use mostly the rectangle function in AutoCAD for this purpose and save my file as AutoCAD 2018 DXF.

There is also a tutorial how to import a .dxf file here:
https://wufi.de/en/service/downloads/

Also there is an example file in your installation path you can have a look at for better understanding. The path usually is:
C:\Program Files (x86)\WUFI\Tools\DXF2WUFI\sockel.dxf

Hope that helped.
Best regards,
Johannes

Christian Bludau
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 1004
Joined: Tue Jul 04, 2006 10:08 pm -1100
Location: IBP Holzkirchen, the home of WUFI
Contact:

Re: DXF-Import (was Exporting raw data from WUFI 2D)

Post by Christian Bludau » Tue Jun 21, 2022 10:02 pm -1100

Note: I split the topic to a new one as it was not related to the topic where it was created first.

Post Reply