How to setup moisture buffering in WUFI Plus

All about the Software WUFI Plus
Post Reply
Alina0826
WUFI User
WUFI User
Posts: 29
Joined: Tue Dec 13, 2016 11:57 am -1100

How to setup moisture buffering in WUFI Plus

Post by Alina0826 » Fri Oct 26, 2018 10:35 am -1100

Hello WUFI Team:

I'd like to set moisture buffering of wood truss in WUFI Plus model.

Can I know how to set the details in WUFI Plus?

Thank you!

Alina

mpazold
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 187
Joined: Wed Jul 11, 2012 11:21 pm -1100

Re: How to setup moisture buffering in WUFI Plus

Post by mpazold » Mon Nov 05, 2018 12:16 am -1100

Hello Alina,

if they are not regarded in the exterior component, you might can add them as interior component with the same zone on both sides (interior and outer side) and set the surface area acording to one side, and the thickness of the component material. Its mostly not necessary to model it in the 3D visualization, you can add it as an not visualized component.

Best,
Matthias

Post Reply