Questions in WUFI Plus Air Flow Model

All about the Software WUFI Plus
Post Reply
hs
WUFI User
WUFI User
Posts: 26
Joined: Mon Mar 01, 2010 2:41 am -1100

Questions in WUFI Plus Air Flow Model

Post by hs » Mon Oct 01, 2018 7:56 pm -1100

We are using Air Flow Model in WUFI Plus V3.1.1.0.
It would be highly appreciated if you could tell us how to implement the following conditions in WUFI Plus with certain switches or functions.

1) Specify the arbitral time series of DB & RH for a supply air not equal to the outdoor air.

2) Output the time series of the specific interzonal air flow rate, for example, interzonal air flow rate of zone A and B, while the zone C exist and connected to zone A as well.
In the application, the interzonal air flow on a zone seems to be sum up for all connected zones.

Thank you in advance for your cooperation.

HS

mpazold
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 168
Joined: Wed Jul 11, 2012 11:21 pm -1100

Re: Questions in WUFI Plus Air Flow Model

Post by mpazold » Mon Nov 05, 2018 12:00 am -1100

Hello HS,

1) At the moment, it's only possible to define, or set supply air condtions with an workaraound. you can add an fictive addtional zone (maybe as an attached zone) with an predefined inner climate and then define the supply air flow from this zone to your building.

2) Only the sum of interzonal air flow is shown and saved as result, if you need to investigate the flow rates in detail you need to check "Retain calculation results" for interzonal components (between Zone A and B, or C), used as flow paths. Then you get the simulated airflow via those components.

Post Reply