Installation of VTT

[hbreaux]

I'm using WUFI Passive/Plus and need to use VTT. However after I install VTT it does not become available as a post-processor. I've checked wufi.ini and it seems to point to the correct place. Any help would be appreciated.

[Sebastian Boegl]

WUFI VTT or WUFI Bio should be displayed in the Film viewer (take a look at the help topic Assessing the results)

[hbreaux]

Thanks, Sebastian. That's where I was looking. I presume VTT should show up as a button like WUFI Bio typically should. Although after installing Bio I stil don't see either in the extended animation window.

[hbreaux]

Also, WUFI Bio doesn't show up anymore either.

[Sebastian Boegl]

Do you have any luck showing the post processors by clicking on the right button named "Extended animation"?

[hbreaux]

No, it's not there. Once I open the extended animation, which opens WUFI Animation 1D, I don't see Bio nor VTT buttons on top menu bar as expected. But both Bio and VTT have been installed.

[Sebastian Boegl]

Please try the following to get this working:

• Append the following to the file %PROGRAMDATA%\WUFI\wufi.ini:

  Code: Select all

  [WUFI6]
  PostProcessorPath=C:\Program Files (x86)\WUFI\PostProc\
  

  If you are unable to save the changes to the file, save it under a different name such as wufi-new.ini, delete the old wufi.ini and rename the file to wufi.ini.
• In order to run the Postprocessors download and install the latest WUFI-JRE from here.

[hbreaux]

Thank you!

I installed WUFI-JRE64 and added that bit of code to wufi.ini. That seemed to have worked.