Search found 5 matches
- Sun Feb 11, 2024 10:20 pm -1100
- Forum: WUFI 2D
- Topic: The air void under the PV installation
- Replies: 1
- Views: 996
The air void under the PV installation
Dear WUFI Users, I am wondering how the case of a photovoltaic installation on a sloping roof (10 degrees of pitch) with a 4 cm air void under the installation should be properly simulated? I have seen articles about flat roof and rack PV installation (model using correction coefficients of 0.3 and ...
- Thu Jan 25, 2024 11:57 pm -1100
- Forum: WUFI Plus
- Topic: How to enable building shading visualization?
- Replies: 0
- Views: 1197
How to enable building shading visualization?
Dear WUFI Users, I've read in the WUFI Tutorial that shading can be visualized during the simulation (WUFI Fundamentals - 6. Shading Model). There are figures that show the shading situation of a building on a chosen day and time. The question is, how to switch it on? I can't find any setting for th...
- Mon Jan 22, 2024 9:41 pm -1100
- Forum: Climate
- Topic: How to disable radiation and rain from climate?
- Replies: 2
- Views: 2016
Re: How to disable radiation and rain from climate?
Dear Christian,
thank you for your advice and additional learning materials. It was really helpful.
Thomas
thank you for your advice and additional learning materials. It was really helpful.
Thomas
- Mon Jan 22, 2024 2:42 am -1100
- Forum: WUFI Plus
- Topic: Aggregating of windows for two directions - WUFI PLUS
- Replies: 0
- Views: 1149
Aggregating of windows for two directions - WUFI PLUS
Dear WUFI users, recently, during calculations, I encountered incorrect results of the DIN4108 simulation after aggregating the windows on N and W into one group (I wanted to cluster them because they did not have blinds). In the results, I noticed that the radiation intensities on both windows were...
- Mon Jan 15, 2024 9:27 pm -1100
- Forum: Climate
- Topic: How to disable radiation and rain from climate?
- Replies: 2
- Views: 2016
How to disable radiation and rain from climate?
I would like to simulate a partition in WUFI-2D in the climate from the database. The partition is roofed and shielded by another partition, so I would like to exclude the effects of rain and radiation from the simulation. Will it be enough that I select in the climate settings: "without absorp...