WUFI

Hei,

I'm trying to simulate a slightly insulated concrete roof that has presented condensation.
The roof is insulated with 5 cm insulation on the interior side.
I'm interested in checking the construction on the wooden stud, so I simulate on WUFI Pro membrane-concrete-wood-gypsum board. the ...

Thank you, Thomas

Hei,

I am working on a case with a CLT wall standing on concrete floor (which is insulated from the inside) and I want to check the hygrothermal conditions on the base of the CLT.
I was checking my fluxes close to the bottom of the CLT and i noticed that my diffusion flux density was at 0. I then ...

Thanks
I'll give it a shot

Thanks for your reply
What would you think would be the best way to simulate wooden beams that are screwed together?
Cause I try to study the difference between using screwed beams together, instead of opaque wooden material
Thank you in advance

Stergiani

Hei,

I need to simulate a roof construction where wood beams have been screwed together.
For that reason, I have build an element that in between the wooden parts, there are very small air gaps 0.1mm, but the simulation doesn't seem to work and I just get an empty convergence analyzer.
If I run it ...

Hei!

I am using the sub-software of WUFI, U-value transient, and I have some problems.
In most of the cases, I get normal values for the U-values, but in one case I get negative values for it.
And when I try to export the results, although the fluxes look normal, the U-values are all zero.
Any idea ...

Thank you for your response.
Works fine now!

S

Hi

I just installed WUFI 2D, but I cannot save any project.
Every time I create a new project and try to save it, I get a message on the bottom left corner 'Error in saving project'
I tried to change the cache directory, but it doesn't allow me to switch it.
Any suggestions?

Thank you,
S